車間粉塵處理的好方法，車間粉塵由吸塵罩通過風管經風機的引力下進入脈沖布袋除塵器，在擋風板的作用下，氣流向上流動，流降低，部分大顆粒粉塵由于慣性作用被分離出來落灰灰斗，細微的含塵氣體進入中箱體濾袋的過濾凈化，粉塵被阻留在濾袋的外表面，凈化后的氣體經濾袋口進入上體箱后高空排放，粉塵由經布袋除塵器的排灰閥排出。

A good method for dust treatment in the workshop. The dust in the workshop enters the pulse bag filter through the suction hood and the suction of the fan through the air duct. Under the action of the wind deflector, the airflow flows upwards and decreases. Some large particles of dust are separated from the ash hopper due to inertia, and fine dust containing gases enter the filtering and purification of the middle box filter bag. The dust is trapped on the outer surface of the filter bag, and the purified gas enters the upper box through the filter bag mouth and is discharged at high altitude. The dust is discharged through the ash discharge valve of the bag filter.

結合廠房面積及加工設備的實際需要風量，設計管路及分支管道，按設備揚塵的大小，來設計管道分支的直徑，粉塵從管道中由負壓風機帶動脈沖袋式除塵設備從，從設備的下風口進入除塵設備灰倉，通過除塵倉的噴吹和吸附，來完成正常氣流的清潔流通，干凈氣體從上風口進入煙筒排除，有沉降室的，粉塵會排入沉降室，沒有沉降室的會用布袋收集起來，由專人清理。

Based on the actual air volume required by the factory area and processing equipment, design pipelines and branch pipelines, and design the diameter of pipeline branches according to the size of equipment dust. Dust is collected from the pipeline by negative pressure fans with arterial flushing bag dust removal equipment, and from the lower air outlet of the equipment, it enters the dust removal equipment ash bin. Through the spraying and adsorption of the dust removal bin, the normal air flow is cleaned and discharged. Clean gas enters the chimney from the upper air outlet, and if there is a settling chamber, the dust will be discharged into the settling chamber. If there is no settling chamber, it will be collected with cloth bags and cleaned by a dedicated person.

上一篇：這三種除塵設備可輕松應對多種車間內的焊煙治理
下一篇：多工位焊煙凈化設備的使用特點